This method statement covers the general requirements for materials and application of external thermal insulation on the hot surfaces of piping and equipment’s as applicable on the project or facilities i.e. boilers, refineries etc. The external surface of equipment, piping and machinery shall be insulated to conserve energy by reducing heat loss and to facilitate […]
Method Statement for Hot Insulation Read More »
HVAC Method Statements
Procedure For Liter Weight of Clinker The liter weight of clinker is a good measure of burn-ability by calculating the density of the clinker. The size of clinker for liter weight is between 5 & 10 mm. A clinker of density approximately 1100 g/ltr is of normal quality, but below than that is not considered a good
Standing Procedure For Liter Weight of Cement Clinker Read More »
Method Statements
Below is a precise exhaust fan installation procedure that covers installation of Axial, Centrifugal and Propeller types of exhaust fans. This standing procedure step wise defines the method that will help to ensure that installation of axial / centrifugal / propeller fan’s, supports, vibration isolators and final connections is done as per project specifications. Also
Exhaust Fan Installation Procedure ( Axial, Centrifugal and Propeller Exhaust Fans) Read More »
Duct Works, HVAC Method Statements
1. PURPOSE This method of statement covers the on construction project site installation of the compressed air piping system for the operation of the chillers. This method statement covers following type of works: Power Plant Compressed Air Systems Factory assembled packaged air compressor complete with: – Rotary screw air compressor – Receiver – Filtration facilities –
Method of Statement For Installation of Compressed Air Piping System for Chillers Read More »
Plumbing Method Statements
Below is a detailed method statement for thermal insulation application on pipes, fittings and equipment connections. Calcium silicate insulation is used for thermal insulation of indoor piping and fittings. Perlite insulation is often used where water entering an insulation system may cause corrosion problems or process problems, for example the outdoor piping, fitting and equipment.
Method Statement for Installation of Thermal Insulation on Pipes Read More »
HVAC Method Statements, Method Statements
This method statement covers on site installation of pre-fabricated ductwork system for kitchen exhaust ducting. Procedure defines the method that will make sure that prefabricated kitchen exhaust ducting including support/bracketing, in line equipment installation and final connections are correct and acceptable, and conforms to the contract documents and specifications. Construction/ Project Manager is overall responsible
Kitchen Exhaust Ducting Installation Method Statement Read More »
HVAC Method Statements, Method Statements
1.0 PURPOSE The purpose of generating this method statement is to define the procedure step by step to implement the correct practices for medium voltage switchgear panel installation & its accessories through the guidelines contained herein so as to ensure that the job execution complies with specifications and serves the intended function to satisfactory level.
Switchgear Installation Method Statement – MV LV HV Switchgear Panels Read More »
Electrical Method Statements
This page presents precise mechanical method statement that covers ahu testing and commissioning procedure. A full method statement shall have many other sections and details depending upon the type and size of units and projects. Prior to testing & commissioning ensure that all the sections of the Air Handling Units are thoroughly cleaned. In case
Method Statement for Testing & Commissioning of Air Handling Units AHU & FAHU Read More »
HVAC Method Statements, Method Statements, Testing & Commissioning