MethodStatementHQ - Method Statement and Construction Methodology

horizontal-bladder-tank-installation Method Statement

Method Statement for Horizontal Four Flange Bladders Installation in Tank

February 2, 2018

Visually inspect bladder for correct size and obvious defects such as perforations before starting. Lay bladder on a dry, clean surface such as a cleanly swept floor, tarp, etc. Smooth out all wrinkles and folds. Roll up the small flange necks at top and bottom of bladder, the use duct tape to tape securely so that they […]

Method Statement for Horizontal Four Flange Bladders Installation in Tank Read More »

Fire Suppression System

Method Statement For Vibro Compaction Works

January 29, 2018

Vibro compaction technique is applicable and effective for the improvement of loose natural fine sands as well as the compaction of Fills. Relative density is improved, potential for liquefaction from a seismic event is reduced, improvement depth up to 20.0 m or even much deeper can be achieved with this technique depending on the size

Method Statement For Vibro Compaction Works Read More »

Civil Engineering Methods

Piling Problems and Risks During Execution Works

January 22, 2018

The following possible risks or problems are identified with the activities involved with pile execution. Survey – Out of Positioning of the Pile The pile position shall be cross-checked by the Engineer, Contractor and Sub Contractor before the installation of pile. If any out of position of the pile (more than the allowable tolerance) has

Piling Problems and Risks During Execution Works Read More »

Civil Engineering Methods

Method Statement for Pile Reinforcement and Concrete Casting

January 15, 2018

Subsequent to the completion of the pile drilling, the borehole depth will be checked and verified versus the depth given on daily piling sequence and pile data. Only after borehole depth check can the cage be lowered into the borehole. A reference site datum level will be given to ensure the correct positioning of the

Method Statement for Pile Reinforcement and Concrete Casting Read More »

Civil Engineering Methods, Method Statement for Civil Works

Method Statement for Piling Works Constructions – Drilling

January 7, 2018

Below is a brief method statement of piling work that can be used for any kind of project piling works. A crawler mounted piling rig will be used to install bored cast in situ piles of dia 1200 mm. The procedure for the construction of bored piles, with temporary casing under bentonite / water support

Method Statement for Piling Works Constructions – Drilling Read More »

Civil Engineering Methods, Construction Method Statements, Method Statement for Civil Works, Method Statements

CCTV Camera Testing & Commissioning Procedure

November 13, 2017

The purpose of this method statement is to specify the detailed requirements and procedure for testing & commissioning of installed CCTV System at a project in accordance to the specification and manufacture’s recommendation to reach the required quality and satisfying the requirements of the client. Below is the list of equipment that shall be used

CCTV Camera Testing & Commissioning Procedure Read More »

Construction Method Statements, Electrical Method Statements, Method Statements, Testing & Commissioning

Concrete Blocks Laying Alignment & Jointing

September 30, 2017

Concrete Blocks are mostly used building material in all parts of the world. Below is a brief method statement that you can utilize for concrete blocks laying alignment & jointing. Blockwork is major activity that requires precise alignment and joining because if the brickwall or blockwall is not straight that may impact wholw shape of

Concrete Blocks Laying Alignment & Jointing Read More »

Civil Engineering Methods

Cartridge Filters UV Sterilization Unit and Chlorine Dosing System Installation

September 5, 2017

Before starting the site installation work domestic water treatment system, ensure all civil works are completed for the area of installation, and civil clearance is obtained from respective authorities to proceed further. Prior to start the installation, refer to the approved shop drawings and BOQ related to the area of installation and ensure that required

Cartridge Filters UV Sterilization Unit and Chlorine Dosing System Installation Read More »

Method Statements, Plumbing Method Statements