The following describes the procedure for filling core sonic pipes with cement grout. Prepare the mix as per the proposed mix design given below...
Latest additions !
Design of Reaction System for 1500 mm diameter Test Pile
The following are the main elements in the design of reaction system for 1500 mm diameter test pile.
Design of Reaction Anchor.
...
Method Statement for Temporary Retaining Wall Installation
The existing ground level varies between + 3.52 m DMD to + 4.29 m DMD. The working platform level for Double U wall is considered at the average...
Method Statement for Horizontal Four Flange Bladders Installation in Tank
Visually inspect bladder for correct size and obvious defects such as perforations before starting.
Lay bladder on a dry, clean surface such as a...
Method Statement For Vibro Compaction Works
Vibro compaction technique is applicable and effective for the improvement of loose natural fine sands as well as the compaction of Fills. Relative...
Piling Problems and Risks During Execution Works
The following possible risks or problems are identified with the activities involved with pile execution.
Survey – Out of Positioning of the...
Method Statement for Pile Reinforcement and Concrete Casting
Subsequent to the completion of the pile drilling, the borehole depth will be checked and verified versus the depth given on daily piling sequence...
Method Statement for Piling Works Constructions – Drilling
Below is a brief method statement of piling work that can be used for any kind of project piling works.
A crawler mounted piling rig will be used...
CCTV Camera Testing & Commissioning Procedure
The purpose of this method statement is to specify the detailed requirements and procedure for testing & commissioning of installed CCTV System...
Method Statement for Installation of Access Control System Panel & Software
Installation of Control Panel for ACS Access Control System.
Mount the controller to a panel using screws. Connect the Ethernet, Service port and...
Concrete Blocks Laying Alignment & Jointing
Concrete Blocks are mostly used building material in all parts of the world. Below is a brief method statement that you can utilize for concrete...
Automatic Transfer Switch & Bypass Isolation Switch Method of Testing & Commissioning
The purpose of this method statement is to outline the sequence & method of Testing & Commissioning of Automatic transfer & Bypass...
Cartridge Filters UV Sterilization Unit and Chlorine Dosing System Installation
Before starting the site installation work domestic water treatment system, ensure all civil works are completed for the area of installation, and...
Car Parking Management System Testing Commissioning Procedure
Electric installation and maintenance work may be carried out only by appropriately qualified licensed electricians. Mains connections must be...
Plate Heat Exchanger Installation Method Statement
Unless otherwise specified, all plate heat exchanger installation shall be in accordance to approved shop drawings, manufacturer instructions and...