METHOD STATEMENT FOR TESTING OF AUTOMATIC TRANSFER SWITCH

METHOD STATEMENT FOR TESTING OF AUTOMATIC TRANSFER SWITCH SCOPE OF WORKS : As part of the Field Quality Control as per specification clause, testing and commissioning of the ATS Panel will be carried out as per the enclosed Method Statement under the direct supervision of factory authorized service representative. SYSTEM COMPONENTS ATS Panel – covered under this method statement TECHNICAL …

Read More »

Cable Tray Installation Method Statement – Cable Ladder & Trunking

Below is the detailed cable tray installation method statement not only for cable tray but applicable for GI ladder and trunking for indoor and outdoor applications and in service rooms like pump rooms, electrical rooms and plant rooms etc. PREPARATION AND SUBMISSIONS BEFORE CABLE TRAY INSTALLATION All materials intended for cable tray, ladder and trunking shall be submitted for approval of …

Read More »

Building Operation & Maintenance Manual Template In Word Format

Below is a complete template which can be used to prepare professional operation and maintenance manuals for building projects of any size and type. Details in each section depends upon the area of application. If project is of high value and more complex operations are involved much detail should be provided in relevant sections like description and operation areas.For small …

Read More »

Operating Instructions sprinkler system, landing valves, hydrant valve, hose reel valve, and extinguishers.

Operating Instructions for fire fighting system including sprinkler system, landing valves, hydrant valve, hose reel valve, and extinguishers. I. SPRINKLER SYSTEM Alarm Valve (i) Setting up of an Installation Control Valve assembly. State of Plant: Fire protection system mains pipework charged to system pressure up to the upstream side of Installation Control Valve. All Normally Closed (NC) Valves on trim …

Read More »

Maintenance Procedure For Fire Sprinkler, Stand Pipe, Hydrant & Hose Reel Systems

Maintenance Instructions for the maintenance of Fire Sprinkler, Stand Pipe, Hydrant & Hose Reel Systems including fire fighting pump sets. Maintenance Of Sprinkler System: Installation of Control Valve (Alarm Valve) It is recommended that the Alarm Valve be inspected periodically to ensure proper operation.  Several areas to be routinely inspected are: Clapper/Clapper Latch: The rubber clapper facing should be checked for wear …

Read More »

Download Method Statement For Compressed Air System Piping Installation

Download Method Statement For INSTALLATION & TESTING OF COMPRESSED AIR SYSTEM Now you can Download Method Statement, ITP, Installation & Pressure Test Checklists and Risk Assessment For Compressed Air System Piping Installation by paying a very nominal fees. The files are in word/excel format and instantly available after you pay the cost of only 2.99$. You only need to change project …

Read More »

Method Statement For Testing & Commissioning Of Fire Fighting Sprinkler System

Instruments & Tools Required for Testing & Commissioning Of Firefighting Sprinkler System Valve operating keys. Calibrated Pressure Gauges Heat gun Torque tester Flexible Hose Drums 300 liter to 500 liter Testing & Commissioning Sequence Pre-Commissioning Phase Below are sprinklers System Pre-Commissioning Checks: Before commissioning the system the following shall be ensured. a) The Installation and pressure testing of the pipes …

Read More »

Method Statement For Testing & Commissioning Of Sump Pumps

Pre-commissioning checks prior to start-up of Sump Pump  a) Mechanical Check and inspect the installation of Sump Pump is complete; verify the installation as per approved drawings. Verify compliance to the attached manufacturer’s installation instructions. Obtain installation certification from manufacturer or their authorized representative. Check and ensure adequate clearance available for service and maintenance of pumps and motors. Check the …

Read More »