Following equipment shall be arranged: Hand tools Air Compressor Wire brush Slow speed drill with Fosroc MR4 mortar mixing paddle Finishing Sponge & rubber gloves SURFACE PREPARATION Mark out the defective area, remove loose sand cement materials and all contamination from screed  such as dust, oil & grease if any up to the perimeter of […]
Method Statement For Repairing Screed Surface Read More »
Civil Works Method Statements
Unless otherwise specified, all plate heat exchanger installation shall be in accordance to approved shop drawings, manufacturer instructions and contract specifications. Drawing plans, schematics, and diagrams indicate general location and arrangement of Heat Exchanger’s. Install Plate Heat  Exchanger’s as indicated unless deviations to layout are approved on coordination drawings. Plate Heat Exchanger shall be installed
Heat Exchanger Installation Testing and Commissioning Method Statement Read More »
HVAC Method Statements, Preventive Maintenance, Testing & Commissioning
1. Introduction This Testing & Commissioning Procedure defines the systematic method for inspection, testing, startup, balancing, and performance verification of ventilation and general exhaust fan systems installed in commercial, residential, industrial, and infrastructure projects. The purpose of this procedure is to ensure that all ventilation and exhaust fans operate safely, efficiently, and in accordance with
Testing & Commissioning Procedure for Ventilation and General Exhaust Fans Read More »
HVAC Method Statements, Testing & Commissioning
Before starting the commissioning of Fire Alarm System, make sure that system installation is complete and approval is available. Verify the absence of unwanted voltage between circuit conductors and ground. Test all conductors for short circuits using an insulating testing device. With each circuit pair, short circuit at the far end of the circuit and
Method Statement for Testing and Commissioning of Fire Alarm System Read More »
Fire Suppression System, Testing & Commissioning
The purpose of this ac duct cleaning method is to remove the inert suspended matter such as foreign objects, moulds etc. HVAC duct cleaning will be done until all suspended matter and loose debris are fully removed from the ducting system. Following tools shall be arranged before starting the ac duct cleaning works of HVAC
AC Duct Cleaning Method Statement Best for HVAC Ducts & Accessories Read More »
HVAC Method Statements
Before starting the construction work, ensure that all necessary work permit and safety requirements are complete. Supervisor to check that safety personnel is available to monitor the construction activity before start of work. HSE site engineer/office will ensure monitoring of the applicable PPE and especially the safety harness for all persons concerned with working at
Method Statement for Installation of Roof Shading Louvers With Aluminium Cladding Read More »
Civil Works Method Statements
Below you can find some major causes of road crack and road defects. The page also provides what are the effects if these road defects are not properly addressed. Alligator Cracking Alligator cracking is a series of interconnecting cracks creating interconnected patterns on the road. The cracks start at the bottom of asphalt surface and
Possible Causes of Road Crack and Defect – Road Maintenance Inspection Guide Read More »
Roadworks