The aim and purpose of aggregate impact test is to determine the impact value of the given aggregate which is to be used in road works. Toughness is the property of a material to resist impact. Due to traffic loads the road stones are subjected to the pounding action or impact and there is possibility […]
Aggregate Impact Test to Find Aggregate Impact Value Read More »
Civil Engineering Methods, Method Statements, Roadworks
The works mentioned in this Section shall apply to maintenance of road and shall be carried out manually or by machinery in such a way that the quality of end product meets the specified requirements. Whenever the Specification is not clear, good engineering practice shall be applied to the satisfaction of the consulting engineer. This
Standard Road Maintenance Routine Requirements Read More »
Civil Engineering Methods, Quality Management, Roadworks
The purpose of this safety procedure is to provide the safety requirements for the use of power actuated fastening tools. This Instruction applies to all applications where power actuated tools are used on a project. Always refer to the power tool operating manual and cartridge operating manual. Hazard Identification and Risk Assessment The introduction of
Explosive Power Tools Operation Safety Instructions Read More »
Civil Engineering Methods, Construction Method Statements, Method Statement for Civil Works, Technical Articles
The scope of this procedure covers methods of concrete curing to achieve specified strength and durability parameters of concrete. Procedure for concrete curing on a project site will vary depending on the type, exposure, location and design mix. It is advised to check the specification and obtain the approval of the Consultant prior to the
Concrete Curing Method of Statement Read More »
Civil Engineering Methods
Below is a precise method of statement that describes the procedure for installation of Drainage Accessories. This document defines the methods to be used to ensure that the plumbing works to be conducted at site are in compliance with the approved designs and approved material submittals. Prior to installation of drainage accessories, the supervisor and
Drainage Accessories Installation Method of Statement Read More »
Method Statements, Piping Method Statements, Piping Works, Plumbing Method Statements
This procedure describes standard procedure for Management of Construction Project Plant Assets. Project plant coordinator is overall responsible for the implementation of this procedure on the construction project. The asset management procedures describes the minimum requirements. Organization will only purchase assets when suitable hire/rental equipment is not available in the market place, and where an
Standard Procedure for Management of Construction Equipment Project Plant Assets Read More »
Civil Engineering Methods, Preventive Maintenance, Project Planning, Roadworks
The purpose of this office hse procedure is to ensure that all offices are designed to mitigate risk and maintained to ensure the safety of staff and visitors. This office safety procedure is applicable for all kind of head/corporate/admin offices including project site offices to maintain good construction safety culture. Overall the office/project manager is
Office Safety Procedure for Workplace Safety Management Read More »
Occupational Health and Safety
The road maintenance contractor shall be responsible for undertaking all routine maintenance of the existing road and all bridges on the road from the day the road is officially handed-over to the client until the issue of Defects Liability Certificate by the engineer. Contractor shall also carry out all the routine maintenance of the completed
Road Maintenance Standard Requirements During Defect Liability Period Read More »
Civil Engineering Methods, Roadworks