The purpose of this Method Statement is to illustrate how plastering work is to be carried out with safework implementation. Plastering method statement defines the methodology of all kind of plastering works related to a construction project covering the main contractor works. This civil method statement also addresses the type and extent of inspections, ITP […]
Plastering Method Statement Read More »
Civil Engineering Methods, Method Statement for Civil Works
This method statement is applicable for the Testing & Commissioning of Fan Coil Units for the project as mentioned in the project specifications & approved shop drawings. Before commencement of FCU testing & commissioning activity, the supervisor must ensure that pre-commissioning of the FCU is complete and approved. Also make sure that all Installations &
Fan Coil Unit FCU Testing Pre-commissioning & Commissioning Method Statement Read More »
Construction Method Statements, HVAC Method Statements, Method Statements, Testing & Commissioning
The purpose of below instrument installation method statement is to set out a clear and defined method of ensuring that the correct control valve is selected and installed in the correct position in the HVAC system. In addition a method is also set out which will ensure that the correct actuators for each specific control
Control Valve & Actuator Installation Method Statement for HVAC System Read More »
HVAC Method Statements, Method Statements
Below is a precise HVAC method statement that briefly explains testing and commissioning of split unit ac air conditioner. The test will be commenced after Split Unit installation and power supply panel T&C activities completed. All areas and fan inlet & outlet should be cleared of waste materials and any other obstruction. The purpose of
Split Unit Testing and Commissioning Method Statement Read More »
HVAC Method Statements, Method Statements, Testing & Commissioning
This method statement covers the general requirements for materials and application of external thermal insulation on the hot surfaces of piping and equipment’s as applicable on the project or facilities i.e. boilers, refineries etc. The external surface of equipment, piping and machinery shall be insulated to conserve energy by reducing heat loss and to facilitate
Method Statement for Hot Insulation Read More »
HVAC Method Statements, Method Statements, Piping Works
Procedure For Liter Weight of Clinker The liter weight of clinker is a good measure of burn-ability by calculating the density of the clinker. The size of clinker for liter weight is between 5 & 10 mm. A clinker of density approximately 1100 g/ltr is of normal quality, but below than that is not considered a good
Standing Procedure For Liter Weight of Cement Clinker Read More »
Method Statements
Below is a precise exhaust fan installation procedure that covers installation of Axial, Centrifugal and Propeller types of exhaust fans. This standing procedure step wise defines the method that will help to ensure that installation of axial / centrifugal / propeller fan’s, supports, vibration isolators and final connections is done as per project specifications. Also
Exhaust Fan Installation Procedure ( Axial, Centrifugal and Propeller Exhaust Fans) Read More »
Duct Works, HVAC Method Statements
1. PURPOSE This method of statement covers the on construction project site installation of the compressed air piping system for the operation of the chillers. This method statement covers following type of works: Power Plant Compressed Air Systems Factory assembled packaged air compressor complete with: – Rotary screw air compressor – Receiver – Filtration facilities –
Method of Statement For Installation of Compressed Air Piping System for Chillers Read More »
HVAC Method Statements, Piping Works