This roadwork method statement describes work methodology for road construction covering the activities from subgrade to asphalt work. All personnel working at site shall have full knowledge and expertise in the excavation, backfilling, compaction and road testing process. Occupational health and safety program shall be properly communicated and implemented. Everyone should be aware of the […]
Method Statement for Road Construction Read More »
Roadworks
The purpose of this method statement is to define the steps to implement the correct practices for the installation of chemical dosing system (pot) for chilled water piping. By following this procedure contractor shall ensure that the performance of the chemical dozing system and equipment complies with the project requirements and serves the intended function
Chilled Water Dosing System Dosing Pot Installation and Testing Method Statement Read More »
HVAC Method Statements, Testing & Commissioning
The purpose of this Method Statement is to illustrate how plastering work is to be carried out with safework implementation. Plastering method statement defines the methodology of all kind of plastering works related to a construction project covering the main contractor works. This civil method statement also addresses the type and extent of inspections, ITP
Plastering Method Statement Read More »
Civil Works Method Statements
This method statement is applicable for the Testing & Commissioning of Fan Coil Units for the project as mentioned in the project specifications & approved shop drawings. Before commencement of FCU testing & commissioning activity, the supervisor must ensure that pre-commissioning of the FCU is complete and approved. Also make sure that all Installations &
Fan Coil Unit FCU Testing Pre-commissioning & Commissioning Method Statement Read More »
HVAC Method Statements, Testing & Commissioning
The purpose of below instrument installation method statement is to set out a clear and defined method of ensuring that the correct control valve is selected and installed in the correct position in the HVAC system. In addition a method is also set out which will ensure that the correct actuators for each specific control
Control Valve & Actuator Installation Method Statement for HVAC System Read More »
HVAC Method Statements
This method statement covers the general requirements for materials and application of external thermal insulation on the hot surfaces of piping and equipment’s as applicable on the project or facilities i.e. boilers, refineries etc. The external surface of equipment, piping and machinery shall be insulated to conserve energy by reducing heat loss and to facilitate
Method Statement for Hot Insulation Read More »
HVAC Method Statements
Procedure For Liter Weight of Clinker The liter weight of clinker is a good measure of burn-ability by calculating the density of the clinker.  The size of clinker for liter weight is between 5 & 10 mm. A clinker of density approximately 1100 g/ltr is of normal quality, but below than that is not considered a good
Standing Procedure For Liter Weight of Cement Clinker Read More »
Technical Articles