In Piping design, sometimes you may have to trim the standard elbow into nonstandard trimmed elbow. This will result additional work and cost to the project. Normally Piping Designers will avoid and should avoid this situation. But if it is unavoidable or the designer thinks that to make the orthographic angle it may require more […]
90 or 45 Degree Elbow Trimming Calculation & Formula Read More »
Quality Management, Technical Articles
ISO 9001 is a quality management system standard that tells us about the requirements for implementing a successful quality management system. The standard is published by International Organization For Standardization i.e. ISO. If a company is willing to establish a standardized quality system in their processes they can follow the requirements of the ISO 9001:2015
ISO 9001 Quality Management System Read More »
Quality Management, Technical Articles
Q. What is QA/QC? QA/QC means, “Quality Assurance/Quality Control” the purpose of this (QA/QC) is to establish the sequence of requirement for the quality of material, quality of works, its inspection and records. Q. What are basic responsibilities of QA/QC personals? To ensure execution of works and comply fully as per standard and approved specs.
Inspection and Quality Control Questionnaires Read More »
Quality Management, Technical Articles
QHSE policy is a top level document that reflects the commitment of top management of a company to its intention of implementing the measures for achieving the quality and HSE targets and objectives. Above the policy there are two more documents which most organizations keep i.e. Mission and vision of the company. In additions a
Sample Quality, Health, Safety and Environmental QHSE Policy Read More »
Quality Management, Technical Articles, Templates
Below procedure will help you to establish a safe standard for the installation of temporary and permanent electrical fixtures/appliances on project sites. Overhead Cables: Overhead supply from the supply point or metering point to the distribution boards on the site should be of a robust pattern and preferably pliable and wire armoured with a further outer
Temporary Electrical Supply HSE Procedure For Construction Site Read More »
Occupational Health and Safety, Technical Articles
On this page we can learn three different soil compaction test methods that are specified in BS 1377. Soil compaction is very important step for any structure because if compaction is not done properly. After the soil compaction is complete a sample is taken in order to fulfill the required quantity of total material as
Soil Compaction Test Methods as per BS 1377 Read More »
Civil Engineering Methods, Quality Management, Technical Articles
Project job descriptions for different job titles are prepared and implemented as part of a good quality management system. Before start of a project normally organization chart is prepared and submitted for the approval of the client and consultant. Some clients provide standard formats for job descriptions on the other hand many contracting companies have
Construction QA/QC Quality Manager & Engineer Job Description Read More »
Quality Management, Technical Articles
The Standard Proctor Test is a laboratory test used to determine the optimum water for a given compaction energy for a given soil. This test is especially useful when determining the relationship between water content and the dry unit weight of soils to establish the maximum density of a soil needed for a fill area. The
Standard Proctor Soil Testing Read More »
Civil Engineering Methods, Technical Articles